How to pump the tyres
Watch this video, https://youtu.be/edFykMFYDKg .
First, remove the stem cap from inner tube. Next, pinch the tyre with one hand behind the stem to push the stem outward. With your other hand, place the head of the pump on the stem as much as possible. Next, lightly bend the stem away from the spokes while keeping the pump on so the lever on the pump can be lifted. This will create an air lock. Pump until the tyre is quite firm to the squeeze but not basketball/ rock hard. If you don’t hear and feel air going in the tyre, try re-attaching. We recommend 25-30 psi not the 35 psi on the sidewall of tyre. For further assistance please contact your local Bumbleride retailer or our customer care department at 03 9588 0999 or info@bumbleride.com.au
Can I purchase a new fabric set?
Yes, we do offer replacement fabric sets for strollers however, colour and quantity may be limited. Please ring 03 9588 0999 or email us info@danishbydesign.com.au
how do I remove or re-attach the fabric set
Please click of the following links to view the instructional videos on Youtube:
How do I wash my Bumbleride
All Bumbleride fabric is composed of a breathable nylon blend for long lasting, colour-safe wear. The seat fabric is removable and machine washable in cold water on a gentle cycle with a mild detergent (Instructions for seat fabric removal below). For tough spots we recommend pre-treating with Oxiclean or another bleach alternative. For 2015 models and older, due to the canopy’s frame construction, we recommend that the canopy is spot washed. 2016/2017 model canopy fabric can be removed and machine washed using same instructions as the seat fabric. Please note that all Bumbleride fabric should be air or line dried. Do not machine dry any Bumbleride fabric.
Seat Removal Instructions: To undo the backrest adjuster buckle/s, make sure child is out and away from stroller, undo the side snaps of the seat fabric near the adjuster belt. Once the strap and buckle is exposed, adjust the backrest flat to create slack in the belt. Next, turn the strap sideways within the small metal buckle and thread out of the small opening. To reattach, re-thread strap through backrest, through seat fabric tab, back around handle, and thread back through buckle.
For further assistance, please contact your local Bumbleride retailer or our customer care at 03 9588 0999 or info@bumbleride.com.au
The front wheel on my stroller is shaking
Please remember that if you are jogging with your stroller the front wheel/s need to be locked. If you are going at a fast pace with the front wheels unlocked the front of the stroller will vibrate.
While it’s possible there are other reasons the front wheel might shake it’s most often related to a loose front fork. You can easily tighten the front fork from home:
Step one:
Locate the Allen key (1/16 inch) that came with the stroller to remove the screws on the hexagon shaped cap
Step two:
Once you have removed the cap and small screws you will see a bolt with a nut attached on top. Use an 18 mm socket wrench to tighten the fork nut.
** This will take some adjusting- if you tighten it too much the wheel may be hard to turn but if it is too loose then the wheel will shake. You will need to adjust it and push the stroller a few times to get it right.
** When you are done adjusting the fork and are putting the hexagon shaped cap back on the stroller please do not tighten the small screws too tight. You may need to access this part again and tightening the screws too much can result in stripping them making it impossible to access the fork nut.